Opening Hour

Mon - Fri, 8:00 - 9:00

WhatsApp

+8618037022596

MAF after replacing maf! engine light came back on! help ...

+

· Went to the dealer for an engine light on. They told me it was the maf...Got the car back with no engine light on (resetted). After reading threads about maf, I decided to save 600 and did it myself, I Love this Forum. 1 unplugged battery negative 2 replaced maf for a new one (matching part...

SOLVED: I replaced the mass air flow sensor in 2005 Fixya

+

I replaced the mass air flow sensor in 2005 Verona, Daewo but the check engine light is still on, Help! We had the car checked on a computer to see what code came up and it was for the air flow mass sensor. we replaced it but the light is still …

The Surprisingly Simple Fix For Check Engine and VSC Lights:

+

My 4runner still passed because all the others were good to go. The recipe for a clear pass: no check engine light, no trouble codes, and all but 1 of your monitors in ready mode. The lesson here is that it’s possible for you to fix any problems and turn all the warning lights off, yet still fail a Drive Clean test.

8 Symptoms Of A Bad MAF Sensor ( Replacement Cost)

+

· MAF Sensor Replacement Cost. The average MAF sensor replacement cost is between 140 and 550, depending on the car model and labor costs. A Mass Air Flow Sensor costs 100 and 400 while the labor costs 40 to 150. The MAF sensor itself is often quite expensive, as you sometimes have to replace the whole MAF sensor housing.

SOLVED: I replaced the mass air flow sensor in 2005 Fixya

+

I replaced the mass air flow sensor in 2005 Verona, Daewo but the check engine light is still on, Help! We had the car checked on a computer to see what code came up and it was for the air flow mass sensor. we replaced it but the light is still on and …

Answered: Check engine light on for mass air flow sensor ...

+

· Mass Air Flow/Check engine light. 2 Answers. Hello! So my Mass Air Flow Sensor popped code about a month and a half ago.. We cleaned it, reset the check engine and about a week and a half later it came back on. I didn''t have the money to get ...

How To Reset Check Engine Light After Replacing Mass Air ...

+

Check engine light after cleaning maf sensor i took apart the air intake this morning to clean the throttle body and maf sensor on my 2006 4runner. Resetting the mass air flow sensor by idling the engine. The check engine light may stay on for a few times after you start the car.

Replace O2 Sensor and still get Check Engine Light On ...

+

· Replaced O2 Sensor and still get Check Engine Light On. 2 different shops did reads on my check engine light codes, I even paid 100 for one of them to do a full test of all sensors to identify which one was bad. Their diagnose was code P0141, oxygen sensor heater, o2 sensor had to be replaced. They said was the front one.

Well I check why my check engine light was on and it said ...

+

· Well I check why my check engine light was on and it said it was the mass air flow sensor. So I replaced it and the car is still sputtering. It said it was running riches well what should I be looking for now. Mechanic''s Assistant: Does the light stay on, or does it blink? The check engine light stays on.

Replaced mass air flow sensor and check engine light still ...

+

Po101 code. Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. Check for air leaks on or around any intake pipework using a good spraying of carb cleaner, if the engine surges then that''s the leak.

SOLVED: All sensors replaced check engine light still on ...

+

all sensors replaced check engine light still on all sensors replaced check engine light still on Ford 2003 Explorer question

Mass Air Flow Sensor Replaced Check engine light still ...

+

· Mass Air Flow Sensor Replaced Check engine light still on! updated! « on: January 26, 2016, 02:54:36 PM » The check engine light came on last week in my 2005 Toyota Matrix.

Cleaned MAF sensor, Check engine light on | Toyota Nation ...

+

· I pulled both EFI fuses for a couple of hours yesterday. Check engine light went out and hasn''t comback on. I used sensor safe silicone and gave it a couple of hours in the warm to set up. The tech article sugested to use sensor safe silicon or allow 24 hours for the non safe silcone to set and cure. Thanks for all the info.

Engine Light Still on After Replacing Oxygen Sensor

+

I am still not sure which oxygen sensor you replaced? I attached an image to show you the correct location of the sensor. Bank 1 sensor 2 is the one on the catalytic converter. Depending on your emissions rating which you will find under …

I replaced my MAF sensor and am still getting the same ...

+

I replaced my MAF sensor and am still getting the same code…. 2007 Nissan Frontier Had code p0171. Tried replacing. 2007 Nissan Frontier code p0171. Tried replacing intake plennum gaskets. Seems better but still getting the code. Short term fuel trim … read more.

reset check engine light | PriusChat

+

· replaced mass air flow sensor and the check engine light is still on. i disconnected the battery, still on. i followed the steps below and the light is still on. any ideas or suggestions? Turn off the car. Put the key fob in the ignition. Hold down the brake and press the power button one time to …

Changed MAF about 2 weeks ago, light still on ...

+

· the check engine light came on a little bit ago and we got it tested and it was the mass air flow sensor, we recently about 2 weeks ago changed it but the engine light remains on and i know its supposed to take a minute to go out but its been longer now, also every time i get gas (it did this before i changed the MAF as well and was a result of needing to change it) and i turn the car back on ...

Chevy Corvette: Bad MAF Sensor → Symptoms Causes ...

+

· The mass airflow sensor (commonly abbreviated to MAF) is one of the most important engine management sensors. A bad mass airflow sensor can leave your Chevy Corvette’s engine running rough, or even inoperable.. A MAF sensor measures the density of the air entering the intake manifold.

Mass Air Flow Sensor Quick test To Tell if Bad or Dirty ...

+

· Quick test to tell if Mass Air Flow Sensor is bad or dirty which could be causing your car or truck to run bad or keep cutting off.

Check engine light still on after cleaning mass airflow s...

+

· Check Engine Light is on Inspection. Get a Quote. David Gaines Wooten. Automotive Mechanic. 25 years of experience. First check to see what codes are being set which cause the Check Engine light to illuminate. This problem may or may not be caused by the mass airflow sensor. If it is the MAF, and cleaning it was unsatisfactory ...

Chevy Mass Air Flow (MAF) Sensor | Symptoms | How to Replace

+

This guide will tackle Chevy Mass Air Flow (MAF) sensor problems, common symptoms, and how to replace the MAF sensor on a Chevy. The engine control unit uses data from the MAF sensor to calculate the correct mixture of air and fuel that the engine needs.

Engine Light Still on After Replacing Oxygen Sensor

+

I am still not sure which oxygen sensor you replaced? I attached an image to show you the correct location of the sensor. Bank 1 sensor 2 is the one on the catalytic converter. Depending on your emissions rating which you will find under the hood on the label the pin configurations are different.

Leave a comment